DECO BEACONS

Adds decorative beacons

DECO BEACON

Beam collides with block
DECO BEACON RECIPE

GHOST DECO BEACON

Beam passes thru blocks
Block has no collision itself
GHOST DECO BEACON RECIPE

OMNI BEACON

Beam can be redirected
OMNI BEACON RECIPE

also has ghost variant
GHOST OMNI BEACON RECIPE

FAKE BEACON

Looks like an actual beacon...
FAKE BEACON RECIPE

Also has ghost variant
GHOST FAKE BEACON RECIPE

HOW TO

TURN ON/OFF

give it a redstone signal to activate the beacon. Toggle ActiveLow mode by R-Clicking it with a redstone torch

SET COLOR

Cycle thru the colors by R-Clicking the beacon with an empty hand. Shift R-Clicking it cycles thru the colors in reverse. R-Clicking it with a dye changes the color. It does not consume the dye.

SET BEACON TRANSPARENCY

DecoBeacon light beams can pass thru other decobeacons and change the beams color. R-clicking with a Sand block makes the surface abrasive and stops the light beam from passing thru. Applying sand to a ghost beacon doesn't stop any light beam from passing thru however it does stop the ghost beacon from affecting the light beam's color

USE GHOSTS

Each beacon has a ghost variant. They work the same way with a few exceptions. Light beams from Ghost beacons pass thru blocks (except opaque beacons). As "ghosts" these blocks don't have collision letting you walk thru them.

### USE BOOK SETTINGS We can write down beacon settings in a Book-&-Quill and apply it to a beacon by R-Clicking. Make sure to separate each setting with a comma "," and recheck what we type in. The beacon will "calmly" point out what we did wrong ### General Settings: - ### activeLow:true/false * if set to true, the beacon is "ACTIVE" when the redstone signal you give it is "LOW" - ### isTransparent:true/false * if set to false, decobeacon light beams cannot pass thru this decobeacon... except if this decobeacon is a ghost variant. * setting this to false on a ghost variant beacon stops the beacon from affecting the passing light beam's color - ### color:white/orange/magenta/light_blue/yellow/lime/pink/gray/light_gray/cyan/purple/blue/brown/green/red/black * set beacon color ### OmniBeacon Exclusive Settings: The following settings only work with omni beacons - ### direction: north/south/east/west/up/down * sets the direction of the light beam - ### maxBeamLenght: integer * sets the max length of the light beam